All Products

Li-ion 18650 3.7V 1800mAh Rechargeable Battery Battery Capacity : 1800 mAh Voltage: 3.7 VoltBattery Size: Diameter- 18mm x Length- 65mmPackage : 1pc ..

Li-ion 18650 3.7V 2600mAh Rechargeable Battery Battery Capacity : 2600 mAh Voltage: 3.7 VoltBattery Size: Diameter- 18mm x Length- 65mmPackage : 1pc ..

Li-ion 18650 3.7V 3800mAh Rechargeable Battery Battery Capacity : 3800 mAh Voltage: 3.7 VoltBattery Size: Diameter- 18mm x Length- 65mmPackage : 1pc ..

This is the LIDAR Lite, a compact high performance optical distance measurement sensor from PulsedLight. The LIDAR Lite is ideal when used in drone, robot, or unmanned vehicle situations where you need a reliable and powerful proximity sensor but don’t possess a lot of space. All you need to communi..

The LilyPad  is a microcontroller board designed for wearables and e-textiles. It can be sewn to fabric and similarly mounted power supplies, sensors and actuators with conductive thread. The board is based on the ATmega168V (the low-power version of the ATmega168) (datasheet) or the ATmega328V..

Sure, your flashing, chip-tune playing t-shirt is really cool at the party... but at some point you need to turn it off. And yes, you could just pull the battery, or maybe you've even sewn a LilyPad slide switch in-line. Wouldn't it be nice if there was just a switch on the battery? Well loo..

This is 30 feet of conductive thread spun from stainless steel fiber and wound on a plastic bobbin. Use it to sew up all of your e-textile projects. This small bobbin is a great way to get into wearable electronics without the upfront cost of buying an entire spool of thread. 30 feet of thread is en..

The ProtoSnap series is a new way to prototype your project without a breadboard. Everything is wired together on a single board, which makes it easy to explore the possibilities of the components before snapping them apart and building them into your project. The ProtoSnap E-Sewing Kit pairs a ..

This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards. It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pi..