Search Criteria
Products meeting the search criteria
Model: CT5A
Current Sensor 5A Single Phase AC ModuleIt has Onboard sampling resistor and precision micro current transformer do accurate sampling for the signal and appropriate compensation, and other functions. The module can measure within 5A current communication, corresponding to output analog quantity can ..
Rs.95.00
Out Of Stock
Model: FS-CT6B
An affordable 6 channel radio controller for quad, airplane, robot etc
Radio Controller Specification:
Channels: 6
Model type: glider/heli/airlane/robot
RF range: 2.40-2.48GHz
Bandwidth: 500KHz
Band: 160
RF power: less than 20 dBm
2.4G system: AFHDS
Code type: GFSK
Sensitivity: 1024
Low..
Rs.2,350.00
Out Of Stock
Brand: Hitec Model: HS75BB
Designed specifically for the landing gear of aircraft.
With its low profile design, strong torque and precision movement, the HS75BB is a great choice to move your retract gear in a realistic manner that you need. Note, this is a retract or “bang bang” servo and only travels from one end to ..
Rs.2,170.00
Model: MAX4466
This MAX4466 Electret Microphone Amplifier with Adjustable Gain Module is best used for projects such as voice changes decibel(dB); audio recording/sampling, and audio-reactive projects that use FFT. On the back, we include a small trimmer pot to adjust the gain. You can set the gain from 25x to 125..
Rs.95.00
2 weeks
Model: MLX90614
MLX90614 Infrared Non-Contact Body Temperature Measurement Sensor Module can be used with any microcontroller that can communicate with it through it's I2C interfaceMultiple zone temperature control up to 127 sensors can be read via common 2 wiresApplication:Body temperature measurementIndustrial te..
Rs.770.00
Model: RFID125USB
This RFID card reader can read RFID card serial number and output to your computer according to the specified format, which may be used for any application including and not limited to food courts, gaming zone, shopping marts etcThe RFID card reader is simple, fast read card. Belong to standard HID ..
Rs.520.00
Model: TP4056CP
TP4056 1A Li-Ion Battery Charging Board with Current ProtectionThe TP4056 constant current-voltage linear charging module for single-cell 3.7 V lithium batteries. During charging and discharging, it will continuously monitor the battery's voltage level and protects against overcharging and underchar..
Rs.15.00
Model: Ardu-BKit
Arduino UNO Kit for Beginners and Robotic Projects, a must have kit for all those starting with microcontrollers.Kit Content :-Arduino UNO - 1pc USB 1.2 meter cable A to B Type - 1 pcArduino character LCD 16x2 - 1 pc10pc M to M, 10pc F to F, 10pc M to F jumper wire4 x 4 keypad - 1pc1pc x 40 pin male..
Rs.770.00
Model: BMS4S20A
BMS 4S 20A 18650 Lithium Battery Protection Boardhigh-accuracy voltage detection circuit;terminal of the charger using high voltage device;Built-in three-stage over-current detection circuit (over-current 1, over-current 2, or load short circuit);MOS transistor can control the battery charge and dis..
Rs.210.00
2 weeks
Model: BMS7S20A
BMS 7S 24V 20A 18650 Battery Protection and Balancing Board will protect battery pack from overcharging, over-discharging over-current and short circuit.It has balancing feature to keep all batteries at same voltage level, that will increase the battery pack efficiency and extend life of battery.Thi..
Rs.590.00
Model: Energy-S
Energy Meter Shield allows to sense active power, reactive power, RMS voltage and current, among other variables, at a given time.
Energy Meter Shield is a board which enables you to monitor your house, office or any other installation or equipment energy consumption, directly with your Arduino ..
Rs.5,750.00
Model: HALL393
It can be used in many applications such as RPM sensor (for counting the number of shaft revolutions), Robot speed and distance measurements, door switch and robot arm position sensor. This module can be used to detect the presence of an magnetic field. The Hall Effect Magnetic and Proximity Sensor ..
Rs.28.00