Parallax PIR Sensor revB Vertical Mount

The PIR (Passive Infra-Red) Sensor is a pyroelectric device that detects motion by measuring changes in the infrared (heat) levels emitted by surrounding objects. When motion is detected the PIR Sensor outputs a high signal on its output pin. This logic signal can be read by a microcontroller or used to drive an external load. Dual output modes and a sensible design that performs within stated datasheet specifications are a few reasons over 100,000 units are in use around the world.

Upgraded & Uncomparable Features

• Longer detection range, selectable by onboard jumper
• Wider supply voltage, from 3 to 6 VDC
• Higher output current provides for direct control of an external load
• Mounting holes included for permanent projects
• All parts SMT

Features:
Detects a person up to approximately 30 ft away, or up to 15 ft away in reduced sensitivity mode

• Jumper selects normal operation or reduced sensitivity
• Approximately 90 degree field of view
• Higher output current provides for direct control of an external load
• Onboard LEDs light up the lens for fast visual feedback when movement is detected
• Mounting holes for 2-56 sized screws
• 3-pin SIP header ready for breadboard or through-hole projects
• Small size makes it easy to conceal
• Easy interface to any microcontroller

Application Ideas:

• Motion-activated nightlight
• Alarm systems
• Holiday animated props

Key Specifications:

• Source current up to 12 mA @ 3V, 23 mA @ 5V
• Voltage requirements: 3 to 6 VDC
• Current requirements: 130 uA idle, 3 mA active (no load)
• Communication: Single bit high/low output
• Dimensions: 1.41 x 1.0 x 0.8 in (3.6 x 2.5 x 2.0 cm)
• Operating temp range:  32 to 122 °F (0 to 50 °C)

Note: All specifications for this product are approximate and subject to change without notice.