The default function of the capacitor touch dimmer is a switch, dimming, with brightness memories LED touch dimming. It will light slowly when turning on the lights, and become dark slowly when turn off, which effectively avoid the stimulation to eyes.

The lamp brightness can be adjusted by requirement, it is very to operate. It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.

Specifications and Features:

The lamp brightness can be adjusted by requirement, it is very to operate.

It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.

Simple applied circuit, less peripheral devices, easy processing, low cost.

Anti-power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.

Application: It can control LED modules, light, and so on. It is available for indoor LED, lighting lamp, DIY automotive lights dimming refit.

Function: Single touch, using the principle of capacitance touch. The default function is a switch, dimming, with brightness memories LED touch dimming. It will light slowly when turning on the lights, and become dark slowly when turn off, which effectively avoid the stimulation to eyes.

Dimming Mode: Non-polar PWM dimming.

Wiring Method: PCB board(VCC, GND) is the power input, (LED+, LED-) is connected with the LED lamps of positive and negative level (fingerprint) touch area, also can wire to lead out (the wiring should not be too long), copper skin area should be 2x3cm. With copper foil, the copper foil board module will side to the shell side.